Uaz 452 clutch and handbrake dimensions.

[wovenrovings]

Hello All,
I am getting organised to do an engine swap into a 452. Anyway I'll start a thread in the Uaz section.
But it would a great assistance if someone had the diameters of the clutch master and slave cylinders. So I can work out if the ratio will still be ok.
Also I am hoping to use the Uaz handbrake. If someone had one laying around and could measure from the backing plate to the drum drive face. Just need to set up the mount plate for it.

Cheers
Daniel.

[funkypete]

My clutch is cable and rod - linkage, its old one tho.

I have a transfer box laying in garage so can have a look.

[wovenrovings]

That would be great Funkypete.

[funkypete]

Sorry, i have taken photos the other day off measurements, then photobucket died whilst i tried to link them on here. Ill try and fire pc up later and get them loaded.

[wovenrovings]

Appreciate the effort Funkypete.